Pearson Edexcel International GCSE (9–1) · CHEMISTRY · Unit
Organic Chemistry
785 practice questions
Topics covered
Practice questions
501–510 of 785
Question 501
1 mark · Easy
Answer and see the solution →Name the catalyst used in the hydration of ethene to make ethanol.
Question 502
3 marks · Easy
Answer and see the solution →(a)[1 mark]What proportion of ethene typically reacts in a single pass through the hydration process?
(b)[1 mark]Describe what happens to the remainder of the ethene.
(c)[1 mark]Explain why this recycling of ethene is important for industry.
Question 503
2 marks · Easy
Answer and see the solution →The hydration of ethene to produce ethanol is shown in the balanced equation below:
Calculate the maximum number of moles of ethanol that can be produced if you start with 12 mol of ethene and excess steam. State your answer clearly.
Question 504
2 marks · Normal
Answer and see the solution →State the word equation and the balanced symbol equation for the reaction to produce ethanol by the hydration of ethene.
Question 505
4 marks · Normal
Answer and see the solution →(a)[1 mark]State the temperature used in the hydration of ethene.
(b)[1 mark]Give the pressure (in atmospheres) required for this reaction.
(c)[1 mark]Name the catalyst used in the hydration of ethene.
(d)[1 mark]Explain why these conditions (temperature and pressure) are used in industry for this reaction.
Question 506
3 marks · Normal
Answer and see the solution →During the hydration of ethene, only 15% of ethene is converted to ethanol in one pass through the reactor. 1000 mol of ethene are used.
Calculate:
(a)[1 mark]The number of moles of ethene that react.
(b)[1 mark]The number of moles of ethene unreacted after one pass.
(c)[1 mark]Explain, in one sentence, why the unreacted ethene is recycled in the process.
Question 507
4 marks · Normal
Answer and see the solution →The table below shows different industrial runs for the hydration of ethene, with the corresponding conditions and yields.
Run Temperature (°C) Pressure (atm) Catalyst Yield of ethanol (%) A 270 60 phosphoric acid 70 B 300 65 phosphoric acid 81 C 325 70 phosphoric acid 84 D 350 55 phosphoric acid 77 (a)[1 mark]Identify the run with the highest ethanol yield.
(b)[1 mark]State the temperature and pressure for this best-yield run.
(c)[1 mark]Describe how increasing temperature affected yield between runs A, B and C.
(d)[1 mark]Suggest one reason why the yield in run D is lower than in run C, even though the temperature is higher.
Question 508
1 mark · Normal
Answer and check →Why is unreacted ethene recycled in the hydration process for making ethanol?
- A.To save costs by heating less gas
- B.To maximise the total yield of ethanol from starting material
- C.To produce a more concentrated ethanol solution
- D.To use less catalyst in the process
Question 509
2 marks · Normal
Answer and see the solution →Give the names of the two reactants required to make ethanol by the hydration of ethene. Write the chemical formula for each.
Question 510
4 marks · Normal
Answer and see the solution →(a)[2 marks]List the three main conditions (temperature, pressure, and catalyst) used for the industrial hydration of ethene to make ethanol.
(b)[1 mark]State why a phosphoric acid catalyst is used in this process.
(c)[1 mark]Explain why the pressure used is not even higher than 70 atmospheres, even though increasing pressure can raise yield.