SubjectCover

Pearson Edexcel International GCSE (9–1) · PHYSICS · Chapter

Electromagnetism

68 practice questions

Topics covered

Practice questions

51–60 of 68

  1. Question 51

    2 marks · Easy

    Describe what happens to the voltage and the current when electrical energy passes through a step-down transformer near a town.

    (a)

    State what happens to the voltage.

    [1 mark]
    (b)

    State what happens to the current.

    [1 mark]
    Answer and see the solution →
  2. Question 52

    1 mark · Easy

    Explain why power lines of the National Grid are placed high above the ground.

    Answer and see the solution →
  3. Question 53

    2 marks · Easy

    The transmission lines carry electricity at a low current. Give two reasons why this is an advantage in the National Grid.

    (a)

    Reason 1:

    [1 mark]
    (b)

    Reason 2:

    [1 mark]
    Answer and see the solution →
  4. Question 54

    1 mark · Easy

    Which part of the National Grid comes immediately after electricity is generated at a power station?

    1. A.Step-down transformer
    2. B.Transmission cables
    3. C.Step-up transformer
    4. D.Domestic fuse box
    Answer and check →
  5. Question 55

    4 marks · Normal

    The diagram below shows part of a National Grid system used to distribute electricity from a power station to homes.

    Geometry diagram with points Power Station, Step-up Transformer, Step-down Transformer, HomesPower StationStep-up TransformerStep-down TransformerHomes
    A simplified National Grid: Power Station, Step-up Transformer, Transmission lines, Step-down Transformer, Homes.
    (a)

    Explain why step-up transformers are used after the power station before transmission.

    [2 marks]
    (b)

    Explain why step-down transformers are used near homes before the electricity enters houses.

    [2 marks]
    Answer and see the solution →
  6. Question 56

    4 marks · Normal

    A step-up transformer in the National Grid has 120 turns on its primary coil and 6,000 turns on its secondary coil. The primary coil is connected to an alternating voltage of 8 V.

    (a)

    Calculate the voltage across the secondary coil.

    [3 marks]
    (b)

    Explain whether this transformer increases or decreases the current in the secondary coil compared to the primary coil, assuming 100% efficiency.

    [1 mark]
    Answer and see the solution →
  7. Question 57

    2 marks · Normal

    Give two reasons why high voltages are dangerous in the National Grid and must be reduced before entering homes.

    Answer and see the solution →
  8. Question 58

    3 marks · Normal

    The table shows information about two types of transformers.

    Transformer data
    Type of transformerNumber of primary turnsNumber of secondary turnsUse in National Grid
    X3009000
    Y4000200

    Complete the table by stating the use of each transformer in the National Grid: either 'step-up' or 'step-down'.

    Answer and see the solution →
  9. Question 59

    4 marks · Normal

    Electricity is transmitted over long distances from power stations to towns.

    Explain in detail, using scientific ideas about current and voltage, how transformers help to reduce energy loss during this transmission.

    (a)

    Describe what happens to the current in the transmission wires when a step-up transformer increases the voltage.

    [2 marks]
    (b)

    Explain why this change in current is important for energy loss.

    [2 marks]
    Answer and see the solution →
  10. Question 60

    4 marks · Normal

    A village receives electricity from a National Grid. The voltage on the transmission cables is 132,000 V.

    (a)

    Give two reasons why a step-down transformer is needed before the electricity enters homes.

    [2 marks]
    (b)

    The step-down transformer reduces the voltage to 230 V. Explain what happens to the current in the secondary coil compared to the primary coil, assuming no energy is lost.

    [2 marks]
    Answer and see the solution →